parametric study - change of initial conditions without exiting the simulation - Abaqus
parametric study - change of initial conditions without exiting the simulation - Abaqus
(OP)
Hi,
I am doinng an parametric study.
Therefore I need to change the inital conditions repeaditly wihtout closing abaqus.
I am capable of looping the simulation, but what I need is to loop the simulation without exiting the simulaiton itself otherwise the simulation would get into the queue (licence) again.
Is there a way of doing this?
Thank you!
I am doinng an parametric study.
Therefore I need to change the inital conditions repeaditly wihtout closing abaqus.
I am capable of looping the simulation, but what I need is to loop the simulation without exiting the simulaiton itself otherwise the simulation would get into the queue (licence) again.
Is there a way of doing this?
Thank you!





RE: parametric study - change of initial conditions without exiting the simulation - Abaqus
Are you new to this forum? If so, please read these FAQ:
http://www.eng-tips.com/faqs.cfm?fid=376
http://www.eng-tips.com/faqs.cfm?fid=1083