I'm fairly new to inventor and not really sure how to proceed on laying this part out.
I'm not sure how to put the 45 degree corners on each end.
I've attached a pdf of what I'm struggling with.
I really appreciate everyone's help.
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
Since the later 1980s, manufacturing companies have seen over 3 percent in labor output year on year, with most of this productivty enhancement occuring because of the optimization of repetitive tasks. Download Now