National Board Forms
National Board Forms
(OP)
I'm currently looking for some guidelines on submitting U-1As, R-1, R-2, NB-136, etc. to the National Board. Our firm has had some forms sent back saying our font size was too small, for example and I would like to have a checklist or guideline which indicates the proper fonts, font size, etc. I have been unable to locate this info in the ASME code book so I'm thinking this must be a National Board rule rather than explicit to ASME. Anyone have a link to a document which might outline something like this?





RE: National Board Forms
RE: National Board Forms
RE: National Board Forms
RE: National Board Forms
I haven't spoken to my supervisors about why they prefer snail mail vs. EDT, but I'm sure they have their reasons. I'll have to check the letter to see the language but from their website it seems like they're pushing EDT. I'm sure it's more efficient for them.
GenB I will have to take a look at the letter we received to see if anything was attached. Presently we are not responding to a letter; my boss just asked that I find the checklist so we won't make the same mistake (or any other mistakes) going forward.