Making a tube through a hole.
Making a tube through a hole.
(OP)
I am trying to make a through tube that ends at a hole.
I have tried making the hole and then making the tube and I get "Unable to perform Boolean".
I have tried making the tube and then making a hole/cylinder/extruding a circle through to the tube face and I always get "Tool and Body do not intersect".
See pictures below. In this case, I have first made my hole and am now trying to make my tube.
http://imgur.com/ozAq6Je
http://imgur.com/C6rXvbI
I have tried making the hole and then making the tube and I get "Unable to perform Boolean".
I have tried making the tube and then making a hole/cylinder/extruding a circle through to the tube face and I always get "Tool and Body do not intersect".
See pictures below. In this case, I have first made my hole and am now trying to make my tube.
http://imgur.com/ozAq6Je
http://imgur.com/C6rXvbI





RE: Making a tube through a hole.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.