How to draw a rectangular bar that is twisted through 90 across its centre, length ways..
How to draw a rectangular bar that is twisted through 90 across its centre, length ways..
(OP)
Hi Guys,
I have a question. A part which I am making out of steel rectangular bar is twisted through 90 degrees plastically across its middle. In manufacture the part is simply held in a jig and twisted 90 degrees from the other end. How would I model this? - the single twist in the middle is my problem...
many thanks for help in advance,
James
Using: NX6
I have a question. A part which I am making out of steel rectangular bar is twisted through 90 degrees plastically across its middle. In manufacture the part is simply held in a jig and twisted 90 degrees from the other end. How would I model this? - the single twist in the middle is my problem...
many thanks for help in advance,
James
Using: NX6





RE: How to draw a rectangular bar that is twisted through 90 across its centre, length ways..
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: How to draw a rectangular bar that is twisted through 90 across its centre, length ways..
thread561-229687: Twisted Flat Bar
www.nxjournaling.com
RE: How to draw a rectangular bar that is twisted through 90 across its centre, length ways..
Many thanks guys...
cheers,
James