Sheetmetal Bend Lines no coming up in flat pattern View
Sheetmetal Bend Lines no coming up in flat pattern View
(OP)
When I make a drawing of a sheetmetal part and select one view as flat pattern, I get bend notes but no bend lines. I went through the properties and still no bend lines. Any ideas?






RE: Sheetmetal Bend Lines no coming up in flat pattern View
Scott Baugh, CSWP
FAQ731-376: Eng-Tips.com Forum PoliciesBerry Plastics
Cad Admin\Design Engineer
GEASWUG Greater Evansville Area SWUG Leader
www.scottjbaugh.com