Reorienting view of part always goes to fron view
Reorienting view of part always goes to fron view
(OP)
I am currently trying to reorient a part in order for the drawing views to to come out alright but whenever I reorient a new view it always goes back to the first view I used.
I reoriented the front view (works out ok). When I ry to reorient the other views it just goes back to the front view after applying my surface references.
I am new to Creo (originally from SolidWorks) so I am still trying to understand the commands to make this work properly. Any ideas?
I reoriented the front view (works out ok). When I ry to reorient the other views it just goes back to the front view after applying my surface references.
I am new to Creo (originally from SolidWorks) so I am still trying to understand the commands to make this work properly. Any ideas?





RE: Reorienting view of part always goes to fron view
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
RE: Reorienting view of part always goes to fron view