NX 8 problem
NX 8 problem
(OP)
I had NX8 working fine till windows crashed. Now when I try and open NX 8 I get a license error and it tries to open in viewer mode. NX 7.5 still works just fine no license issues. NX is hosted off of a network drive and works fine on other workstations. I have deleted the folders that area created under C:\Users\user\AppData\Local\Unigraphics Solutions hoping that would fix it. Is there any other place to look to fix this issue?
This is the error I get after I ok the error NX opens and in the top it says NX viewer 8- and everything is grayed out.
This is the error I get after I ok the error NX opens and in the top it says NX viewer 8- and everything is grayed out.





RE: NX 8 problem
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 8 problem
RE: NX 8 problem
RE: NX 8 problem
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.