*NSET
*NSET
(OP)
I have created a SET in the ASSEMBLE module CAE to get a set of nodes for results output. The set is surface-based. However, the resulting *Nset does not contain all of the nodes on the selected surfaces making up the SET. Anyone familiar with this? I use version 6.12-2 Windows, Thanks in advance.





RE: *NSET
I am not sure what you mean. Was the set you created a node set or an element set? If the surface on which the nodes were selected is not flat, you may have to play with the "angle" a little to make sure /CAE detects all nodes of interest.
Are you new to this forum? If so, please read these FAQ:
http://www.eng-tips.com/faqs.cfm?fid=376
http://www.eng-tips.com/faqs.cfm?fid=1083
RE: *NSET
RE: *NSET
Are you new to this forum? If so, please read these FAQ:
http://www.eng-tips.com/faqs.cfm?fid=376
http://www.eng-tips.com/faqs.cfm?fid=1083
RE: *NSET