Components Blanking Upon Insertion
Components Blanking Upon Insertion
(OP)
NX6.0.5.3
Sometimes when adding components to an assy, they come in blanked, but usually not. Is there a setting that controls this?
TIA!
Sometimes when adding components to an assy, they come in blanked, but usually not. Is there a setting that controls this?
TIA!
“Know the rules well, so you can break them effectively.”
-Dalai Lama XIV





RE: Components Blanking Upon Insertion
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Components Blanking Upon Insertion
“Know the rules well, so you can break them effectively.”
-Dalai Lama XIV
RE: Components Blanking Upon Insertion
View -> Camera -> Edit...
...and in the 'Clipping' section of the dialog, press the 'Fit Planes to Extents' button and then hit OK to leave the dialog.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Components Blanking Upon Insertion
“Know the rules well, so you can break them effectively.”
-Dalai Lama XIV