4 axis toolpath / pocket / NX7.5
4 axis toolpath / pocket / NX7.5
(OP)
Hi,
Can somone help me to make 4 axis toolpath to mill the pocket as per attached file and picture?
Can somone help me to make 4 axis toolpath to mill the pocket as per attached file and picture?





RE: 4 axis toolpath / pocket / NX7.5
----
kukelyk
RE: 4 axis toolpath / pocket / NX7.5
I cannot open this file as it was made in the newer NX version I have. I have NX7.5.
Is it possible for you to send it in NX7.5 format? Or make a movie and upload it here?
I would like to understand the way you do it.
RE: 4 axis toolpath / pocket / NX7.5
----
kukelyk
RE: 4 axis toolpath / pocket / NX7.5
How did you manage to limit the toolpath using the line?
I was looking through the option for the toolpath, but I did not find it and I'm wondering how did you do that.
RE: 4 axis toolpath / pocket / NX7.5
Take a look at the attached undemanding picture
----
kukelyk
RE: 4 axis toolpath / pocket / NX7.5
Thanks again.