Not So Simple Thermal Problem
Not So Simple Thermal Problem
(OP)
Hi,
I want to create a thermal load that removes heat from the system based on the ambient temperature. How do I do this in Ansys 13?
I want to create a thermal load that removes heat from the system based on the ambient temperature. How do I do this in Ansys 13?





RE: Not So Simple Thermal Problem
RE: Not So Simple Thermal Problem
Capacity
16W @ 50k
23W @ 60K
30W @ 70K
37W @ 80K
We are using two of them to cool a small vacuum system. I would ideally like to see a temperature convergence. Is this possible?
RE: Not So Simple Thermal Problem
http://ansys.net/ansys/tips_sheldon/STI09_ANSYS_6....