NX "Internal Error" Upon View Updating
NX "Internal Error" Upon View Updating
(OP)
Hello All:
I keep receiving the following error (see attachment) in drafting while trying to import a base view. I have tried changing my view preferences to 'delay update upon creation' and then manually updating, but I still get the error.
I don't even know where to start trouble-shooting this? Anyone have any ideas as to what common causes might be? The model I have loaded is the same model I am using in other drawings successfully, so I really can't tell what's going on here.
Thank you.
NX7.5.3 TC8.
I keep receiving the following error (see attachment) in drafting while trying to import a base view. I have tried changing my view preferences to 'delay update upon creation' and then manually updating, but I still get the error.
I don't even know where to start trouble-shooting this? Anyone have any ideas as to what common causes might be? The model I have loaded is the same model I am using in other drawings successfully, so I really can't tell what's going on here.
Thank you.
NX7.5.3 TC8.
Using NX 7.5.3 & Teamcenter 8





RE: NX "Internal Error" Upon View Updating
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX "Internal Error" Upon View Updating
Using NX 7.5.3 & Teamcenter 8
RE: NX "Internal Error" Upon View Updating
http://support.industrysoftware.automation.siemens...
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX "Internal Error" Upon View Updating
Thanks for the direction. I'll give it a shot.
Using NX 7.5.3 & Teamcenter 8