thrust blocks for pipe
thrust blocks for pipe
(OP)
Hi
I need to design a thrust block for a 400 OD SDR17 PE with 45 degree bend, 123 l/s at a pressure of 1.5 bar. I never design a thrust block before I would appreciate if somebody can point me in the right direction.
Many thanks
I need to design a thrust block for a 400 OD SDR17 PE with 45 degree bend, 123 l/s at a pressure of 1.5 bar. I never design a thrust block before I would appreciate if somebody can point me in the right direction.
Many thanks





RE: thrust blocks for pipe