FLANGE - NX7.5
FLANGE - NX7.5
(OP)
Hi,
Previous NX version had Flange aside of Sheet Metal.
I use on a regular basics Sheet Metal for Flanges but a work mate does not know how to use Flange other than the one that was located in Modeling(he doesn't know Sheet Metal and has no time to learn it).
What happen with the previous Flange feature?
Previous NX version had Flange aside of Sheet Metal.
I use on a regular basics Sheet Metal for Flanges but a work mate does not know how to use Flange other than the one that was located in Modeling(he doesn't know Sheet Metal and has no time to learn it).
What happen with the previous Flange feature?
MZ7DYJ





RE: FLANGE - NX7.5
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: FLANGE - NX7.5
As far as i remember many sheet metal operations tucked in the modeling tools used the advanced sheet metal license only (let us say multibend bracket,metaform etc and for others it used the basic sheet metal license) .Perhaps from the user point of view i found it a bit confusing to find some sheet metal operations in NX SHEET METAL and some in Modeling (i feel it is better consolidated now and more user friendly).And more over many functionalities achieved the same results (let us say flange ,cutouts etc. which was there in both).
Best Regards
Kapil Sharma
RE: FLANGE - NX7.5
Yes, I agree with you the the new Sheet Metal tool is very powerfull.
I use it on a regularar basics for brackets.
MZ7DYJ