MEDIAL AXIS TRANSFORM in Nx
MEDIAL AXIS TRANSFORM in Nx
(OP)
Hi all,
Any ideas for creating a "MEDIAL AXIS" for a 2d or 3d part in Nx ..?
Link
(See the attached image and please research in the internet for more info on Medial axis)
Thx in advance,
Guija
Running Nx7.5 on Xp
Any ideas for creating a "MEDIAL AXIS" for a 2d or 3d part in Nx ..?
Link
(See the attached image and please research in the internet for more info on Medial axis)
Thx in advance,
Guija
Running Nx7.5 on Xp





RE: MEDIAL AXIS TRANSFORM in Nx
Regards,
Tomas
RE: MEDIAL AXIS TRANSFORM in Nx
----
kukelyk
RE: MEDIAL AXIS TRANSFORM in Nx
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: MEDIAL AXIS TRANSFORM in Nx
@ kukelyk
Wonderful improvisation of the Extrude/draft command. This would work OOTB on profiles with straight edges. But for curved edges it would fail. Yeah you can draft it again and again, but that isn't automatable..
Also this would yield a "STRAIGHT SKELETON" and not the "MEDIAL AXIS" of a profile. Please excuse me if I am throwing up jargons..
This I need as a part of automating the design of Extrusion dies for aluminium.
Thanks again all.