How to switch from drafting to modeling application using NXOpen ?
How to switch from drafting to modeling application using NXOpen ?
(OP)
Hello Everyone ,
Can someone help me out if there is a way to switch from drafting to modeling application using NXOPEN in NX7.5?
Thanks,
Amitabh
Can someone help me out if there is a way to switch from drafting to modeling application using NXOPEN in NX7.5?
Thanks,
Amitabh





RE: How to switch from drafting to modeling application using NXOpen ?
Not in 7.5. In NX 8 the method ApplicationSwitchRequest has been added for that purpose.
www.nxjournaling.com