CATIA 3d Section Fill Problem
CATIA 3d Section Fill Problem
(OP)
Hi, does any body knows why sometimes catia won´t fill the 3d
section in the assembly with the native colour of each part,
and instead it leaves them in a transpartent cut? For example,
this happens when the sectioning area is smaller than the
assembly... I used t think that it is beacause there is an
interference between some parts...Thanks a lot.
section in the assembly with the native colour of each part,
and instead it leaves them in a transpartent cut? For example,
this happens when the sectioning area is smaller than the
assembly... I used t think that it is beacause there is an
interference between some parts...Thanks a lot.





RE: CATIA 3d Section Fill Problem
Try inverting the normal of the sectioning plane. The button is called Invert Normal. It is this button
Hope this helps,
Best of luck!
CATIA V5R19 – user & trainer
ANSYS – beginner
RE: CATIA 3d Section Fill Problem