Arrangements in drafting
Arrangements in drafting
(OP)
Hi everyone,
I created a base view of my assembly using one of my arrangements. I created another base view of my assembly using a different arrangement. However, I now want to change the arrangement of my second base view of my assembly. I tried going in the style, base tab, but I can`t change the arrangement for that view. The section is completely grayed out. Any clues on this issue? (NX 7.5)
Wilson
I created a base view of my assembly using one of my arrangements. I created another base view of my assembly using a different arrangement. However, I now want to change the arrangement of my second base view of my assembly. I tried going in the style, base tab, but I can`t change the arrangement for that view. The section is completely grayed out. Any clues on this issue? (NX 7.5)
Wilson





RE: Arrangements in drafting
www.nxjournaling.com
RE: Arrangements in drafting
So such action will not be supported in NX 7.5? how about newer versions?
RE: Arrangements in drafting
Not that I'm aware of. And since the referenced thread is less than 2 weeks old, John would probably have mentioned if it were supported in NX8 or 8.5.
www.nxjournaling.com
RE: Arrangements in drafting
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.