How to Customize the click to show layer and linetype?
How to Customize the click to show layer and linetype?
(OP)
Hey
Just a simple question.
Im using Acad14 at work and Acad 2000 at home. At work when i click on a line , without first typing a command (eg. the two blue boxes show up at the end of the line), the layer and linetype is imediately displayed in the layer and linetype menus, therefore i know what layer this line is in automatically.
But when in Acad 2000, when i click on the line , the layer or linetype is not displayed as above
How do i customize it so that my Acad 2000 works as the Acad 14?
Thanks
Daniel Dorall
Akiprima.
Just a simple question.
Im using Acad14 at work and Acad 2000 at home. At work when i click on a line , without first typing a command (eg. the two blue boxes show up at the end of the line), the layer and linetype is imediately displayed in the layer and linetype menus, therefore i know what layer this line is in automatically.
But when in Acad 2000, when i click on the line , the layer or linetype is not displayed as above
How do i customize it so that my Acad 2000 works as the Acad 14?
Thanks
Daniel Dorall
Akiprima.





RE: How to Customize the click to show layer and linetype?
The AutoCAD 2000 is similar to AutoCAD R14 for the mentioned facility. It seems there is some problems with your AutoCAD 2000.
:)
Farzad
RE: How to Customize the click to show layer and linetype?
Hope that this helps.
Charles S. Parnell
Southern Store Fixtures
RE: How to Customize the click to show layer and linetype?
Good suss cparnell ... have a gold star.
I've been trying to figure this out since I last upgraded.
David
RE: How to Customize the click to show layer and linetype?
Command: pickfirst
Enter new value for PICKFIRST <0>: 1