PMI using feature parameter
PMI using feature parameter
(OP)
Hello,
In the drafting mode there is a command called “feature parameter” that allows me to call out the information for a threaded hole including the depth, size and thread.
I need to know that the equivalent command to do this in pmi is.
In the drafting mode there is a command called “feature parameter” that allows me to call out the information for a threaded hole including the depth, size and thread.
I need to know that the equivalent command to do this in pmi is.





RE: PMI using feature parameter
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.