while displaying a part attribute in an identification symbol information isn't truncating
while displaying a part attribute in an identification symbol information isn't truncating
(OP)
When using a part attribute that has a data type of "number" and dimesionality of "unitless" units of "unitless" and I then try display this in an identification symbol. It displays with 10 zeros following it. I want it to display the whole number only...Its not an option to change anything in the attribute, because everything is grayed out except the actual value. The information does appear correctly in the parts list... just the id symbol is screwy
NX 6.05.3/7.5.5/8.0





RE: while displaying a part attribute in an identification symbol information isn't truncating
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: while displaying a part attribute in an identification symbol information isn't truncating
NX 6.05.3/7.5.5/8.0
RE: while displaying a part attribute in an identification symbol information isn't truncating
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: while displaying a part attribute in an identification symbol information isn't truncating
NX 6.05.3/7.5.5/8.0