NX7.5 - DIAMETER DIMENSION
NX7.5 - DIAMETER DIMENSION
(OP)
Hi,
Please, have a look at the attached picture:
The diameter dimension I placed shows the real value of the tube, but it looks awful (the arrows of the Ø dimension do not touch the edge that has been selected)
How could I create this dimension in order to reflect the intended geometry?
Thanks
Please, have a look at the attached picture:
The diameter dimension I placed shows the real value of the tube, but it looks awful (the arrows of the Ø dimension do not touch the edge that has been selected)
How could I create this dimension in order to reflect the intended geometry?
Thanks
MZ7DYJ





RE: NX7.5 - DIAMETER DIMENSION
In your case it would appear that you need to move it to align with the MINOR diameter of the 'ellipse'.
This is the sort of situation where an auxiliary view might be called for.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX7.5 - DIAMETER DIMENSION
MZ7DYJ