NX7.5: Sheet body only Visible from one side
NX7.5: Sheet body only Visible from one side
(OP)
Hey everyone,
I am hoping someone on here can help me out with an issue I am having. For some reason when I create a sheet body in NX7.5 it is only visible from one side, that is I can see the sheet I made but when I rotate the component I see right through the sheet. This also seems to happen randomly with other components that I bring into an assembly. It may be just a setting but im really not sure. Any help would be greatly appreciated.
I am hoping someone on here can help me out with an issue I am having. For some reason when I create a sheet body in NX7.5 it is only visible from one side, that is I can see the sheet I made but when I rotate the component I see right through the sheet. This also seems to happen randomly with other components that I bring into an assembly. It may be just a setting but im really not sure. Any help would be greatly appreciated.





RE: NX7.5: Sheet body only Visible from one side
Preferences -> Visualization Performance -> General Graphics, un-check the "Backface Culling" option.
Preferences -> Visualization -> Visual (General Display Settings), turn on the "Two sided light" option.
www.nxjournaling.com