End of View Line Break...
End of View Line Break...
(OP)
Is there such a thing? I'm looking for a line you add to the end of the view that denotes that the part continues but is not shown in this view.
SW Premium 2012
64 bit SP1.0
Intel Xeon X5650 E5-1603 0 @ 2.80 GHz
8.0 GB of RAM






RE: End of View Line Break...
For that, I use "Crop View", and create my own Zig-zag lines in the sketch I use for the Crop View outline. Kind of a pain, but sometimes you just need a view break that the limited options in the "Break View" command just doesn't provide....
Steve R.
RE: End of View Line Break...