NX step to Catia translation
NX step to Catia translation
(OP)
Hello,
We currently working in a multi cad enviroment with both NX7.5 & Catia v5R21.
Just wondering if anyone knows of a translator that can cover over NX attributes to Catia? I've been trying the Step translator without success. I thought when translating metadata the attributes would be translated too.
Any help would be greatly appreciated.
We currently working in a multi cad enviroment with both NX7.5 & Catia v5R21.
Just wondering if anyone knows of a translator that can cover over NX attributes to Catia? I've been trying the Step translator without success. I thought when translating metadata the attributes would be translated too.
Any help would be greatly appreciated.





RE: NX step to Catia translation
Try JT format.As far as i know JT is supported in CATIA V5 also.Normally STEP will enable appending the PMI information along with it but i am not sure if it can carry the NX attributes also.
Best Regards
Kapil Sharma
RE: NX step to Catia translation
I have never used it, but I know it's out there.
RE: NX step to Catia translation
and you will see Catia options in the pull-down
RE: NX step to Catia translation
I'm hoping to get a trial to do some testing. Will be intereted to see the results.
Thanks
RE: NX step to Catia translation
RE: NX step to Catia translation
Anthony Galante

Technical Resource Coordinator
NX5.0.6, NX6.0.5, NX7.5.0-> NX7.5.5 & NX8.0.0 -> NX8.0.3.4, NX8.5.0.23