Error meshing area 188. Redefine number of divisions on boundary or adjust element size parameter
Error meshing area 188. Redefine number of divisions on boundary or adjust element size parameter
(OP)
I usually only use ansys for simpler designs than what I've been given now so I can say that I only have very basic knowledge.
How do I get this meshed?
I tried changing the number of elements on the lines surrounding the area by using ndiv. However, no matter what number of divisions I seem to choose I keep getting the error.
Thanks for any reply.
How do I get this meshed?
I tried changing the number of elements on the lines surrounding the area by using ndiv. However, no matter what number of divisions I seem to choose I keep getting the error.
Thanks for any reply.




