NX 7.5 - Drafting Expand view restore
NX 7.5 - Drafting Expand view restore
(OP)
How could I restore in 2D the view in Expand environment?
Last company I worked for had CTRL+F1 or SHIFT+F1 for this command…….
Thanks
Last company I worked for had CTRL+F1 or SHIFT+F1 for this command…….
Thanks
MZ7DYJ





RE: NX 7.5 - Drafting Expand view restore
www.nxjournaling.com
RE: NX 7.5 - Drafting Expand view restore
While I am in Expand view, I rotate the geometry.
I'd like to get back the view position that is previously expanding......
MZ7DYJ
RE: NX 7.5 - Drafting Expand view restore
You may want to establish the view you had before.......
MZ7DYJ
RE: NX 7.5 - Drafting Expand view restore
www.nxjournaling.com
RE: NX 7.5 - Drafting Expand view restore
That will orient the view to the normal plane you see it at when starting. Is that what you were wanting?
RE: NX 7.5 - Drafting Expand view restore
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 7.5 - Drafting Expand view restore
MZ7DYJ
RE: NX 7.5 - Drafting Expand view restore
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 7.5 - Drafting Expand view restore
MZ7DYJ
RE: NX 7.5 - Drafting Expand view restore
Thanks a lot!
MZ7DYJ