Can anyone help me I have just purc
Can anyone help me I have just purc
(OP)
Can anyone help me I have just purchased a 1988 fanuc tape cut wire edm and it has no cutting condition tables I am using .25mm dia wire
I will be cutting copper,tool steel (various grades),high quality carbon steel (en24 ect),brass,aluminium
I have used the same controll for years on my hitachi Q cut but the generator is a different type and the cutting conditions I have for that won't work at all
Any help would be much apreceated thanks in advance
I will be cutting copper,tool steel (various grades),high quality carbon steel (en24 ect),brass,aluminium
I have used the same controll for years on my hitachi Q cut but the generator is a different type and the cutting conditions I have for that won't work at all
Any help would be much apreceated thanks in advance





RE: Can anyone help me I have just purc
RE: Can anyone help me I have just purc
It's like trying to bake a cake without a recipe