NX 7.5 - Draft Management
NX 7.5 - Draft Management
(OP)
Hi,
Please, open the attachment.
I'd like to know if the Draft Body could get the shape that I finally got using two additional operation (extrude and Trim Body).
Not sure if Draft Body (or other NX tool) could do that (I tried but with no result!). I tried using a negative value for the Draft, but it doesn't work.
Thanks!
Please, open the attachment.
I'd like to know if the Draft Body could get the shape that I finally got using two additional operation (extrude and Trim Body).
Not sure if Draft Body (or other NX tool) could do that (I tried but with no result!). I tried using a negative value for the Draft, but it doesn't work.
Thanks!
MZ7DYJ





RE: NX 7.5 - Draft Management
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 7.5 - Draft Management
Catia V5's Draft function does give both option of removing or adding material.
But Mr. Baker's example is very useful for the full understanding (and applying) of the last Synchronous option that was unclear for me: Symmetric.
That's nice.........
Thanks a lot!
MZ7DYJ
RE: NX 7.5 - Draft Management
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 7.5 - Draft Management
MZ7DYJ
RE: NX 7.5 - Draft Management
You were faster than me!
Thanks again!
MZ7DYJ