Femap : Revolve Parabolic element
Femap : Revolve Parabolic element
(OP)
Hi,
I am trying to revolve parabolic elements on a plane surface in FEMAP 10 but because the elements lies on the axis of revolution it doesn't create the wedge type elements at the axis of rotation. If I revolve linear elements it work fine but i don't get a smooth round revolve that i would get with midside node
Any idea?
I am trying to revolve parabolic elements on a plane surface in FEMAP 10 but because the elements lies on the axis of revolution it doesn't create the wedge type elements at the axis of rotation. If I revolve linear elements it work fine but i don't get a smooth round revolve that i would get with midside node
Any idea?





RE: Femap : Revolve Parabolic element
Idon't see the "photo", please post any picture here to understand your problem, then try to give you any solution -- thanks!.
Best regards,
Blas.
~~~~~~~~~~~~~~~~~~~~~~
Blas Molero Hidalgo
Ingeniero Industrial
Director
IBERISA
48011 BILBAO (SPAIN)
WEB: http://www.iberisa.com
Blog de FEMAP & NX Nastran: http://iberisa.wordpress.com/
RE: Femap : Revolve Parabolic element
http://www.eng-tips.com/viewthread.cfm?qid=337244
Best regards,
Blas.
~~~~~~~~~~~~~~~~~~~~~~
Blas Molero Hidalgo
Ingeniero Industrial
Director
IBERISA
48011 BILBAO (SPAIN)
WEB: http://www.iberisa.com
Blog de FEMAP & NX Nastran: http://iberisa.wordpress.com/