NX Advanced Simulation
NX Advanced Simulation
(OP)
Hye All,
I would like to ask a question on NX Advanced Simulation settings. I am working on a hinge separation test analysis.
From the actual test, they run the test by pulling the hinge in both linear opposite direction at 5mm/min until failure.
The problem is I do not know how to apply the 5mm/min setting in this NX Nastran structural analysis. Anybody have the ideas?
I would like to ask a question on NX Advanced Simulation settings. I am working on a hinge separation test analysis.
From the actual test, they run the test by pulling the hinge in both linear opposite direction at 5mm/min until failure.
The problem is I do not know how to apply the 5mm/min setting in this NX Nastran structural analysis. Anybody have the ideas?





RE: NX Advanced Simulation
You need to add a SPCD. find herewith a jpeg file
I hope this help
Regards
Didier Psaltopoulos
http://www.psi-cad.com