Dynamic load
Dynamic load
(OP)
Hi guys, I'm designing a crushing station which has a dynamic load from an ore crusher. All information I got is the mass of the crusher of 450kN. I made a model on STAAD Pro, but have no idea how to determine and apply the dynamic load on it. Any hints or suggestions for resources or books that refer to this problem? Thanks






RE: Dynamic load
You definitely need more information about the crusher. I doubt you will find the needed information in any text or handbook.
You will need things like the dynamic loads applied, including direction, frequency, ampltude and point of application. Also the cg location. Drawings showing arrangement of the crusher including anchor bolts is also needed. You should ask the equipment vendor for this data.
Regards,
chichuck
RE: Dynamic load
RE: Dynamic load
RE: Dynamic load
RE: Dynamic load
At this point: most equipment manufacture’s can give you this (unless we are talking fan manufacturers, and that's not hard to figure). Most do an FEA analysis, ergo they needed that force themselves.
RE: Dynamic load
Cheers,