FF Vs HART - Differences and Comparision
FF Vs HART - Differences and Comparision
(OP)
I read lot of literature about the difference and comparison between Foundation Feildbus and HART protocol.
Being a Mechanical Engineer, what is understand is that HART gives 4-20mA output signal. It is analog.
Where as FF is digital signal that can be interfaced with a DCS.
Hope i am not too far from what these actually are. A simple understanding and comparison between the two will be appreciated.
Thanks
Being a Mechanical Engineer, what is understand is that HART gives 4-20mA output signal. It is analog.
Where as FF is digital signal that can be interfaced with a DCS.
Hope i am not too far from what these actually are. A simple understanding and comparison between the two will be appreciated.
Thanks






RE: FF Vs HART - Differences and Comparision
hart foundation fieldbus comparison
You'll get a zillion answers, from industry standards, emerson, E+H, etc...
Best to you,
Goober Dave
Haven't see the forum policies? Do so now: Forum Policies