Creo Parametric 2.0 parameters
Creo Parametric 2.0 parameters
(OP)
I'm relatively new to Creo, and have a couple questions regarding parameters. I notice that Creo is pulling parameters from many different sources. Where is it pulling the values for parameters like PDMREV and PROI_REVISION/PROI_VERSION? The source only says "PDM" which doesn't really tell me much. The reason I ask is that I also have in my parameters PTC_WM_VERSION, PTC_WM_REVISION, and PTC_WM_ITERATION which show the source as Windchill. Thanks!
Jeff Parham
Colorado School of Mines '09
Mecahnical Design Engineer





RE: Creo Parametric 2.0 parameters
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli