CATIA V5 R19_Creation of 3D Point
CATIA V5 R19_Creation of 3D Point
(OP)
Good day to everybody,
Using Part Design of Generative Surface Design:
Please, anybody know which command and procedure I have to follow in order to create a 3D point made from the intersection of 3 planes?
Kind Regards,
Diego
Using Part Design of Generative Surface Design:
Please, anybody know which command and procedure I have to follow in order to create a 3D point made from the intersection of 3 planes?
Kind Regards,
Diego





RE: CATIA V5 R19_Creation of 3D Point
To get the point where 3 planes intersect, first use the Intersection command to intersect two of the planes and then intersect the resulting line with the third plane.
RE: CATIA V5 R19_Creation of 3D Point
indocti discant et ament meminisse periti