Part number as note or balloon
Part number as note or balloon
(OP)
I'm doing a drawing in NX8, it's a large assembly, but i'm only doing a few simple assembly views to aid the fitters.
I don't have a parts list on the drawing, but i'd like to balloon, or text note with leader, to identify some of the parts.
Is there a way to do this without creating a dumb note?
I've tried relationships, and <W$@COMPONENT_NAME> without success
I don't have a parts list on the drawing, but i'd like to balloon, or text note with leader, to identify some of the parts.
Is there a way to do this without creating a dumb note?
I've tried relationships, and <W$@COMPONENT_NAME> without success





RE: Part number as note or balloon
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Part number as note or balloon
RE: Part number as note or balloon
Hm, i did not figure out how to make the "ballon" into "note" unless i used autoballon. But then you might find a way to isolate the named components in the partslist.
See attached image.
Regards,
Tomas