codes to restart a simulation from previous results
codes to restart a simulation from previous results
(OP)
Dear all,
I am starting on abaqus and this question can seem obvious but I was wondering if It's possible to start a calculation from previous results on ABAQUS. By the way, I am trying to simulate the deformation of a pipe under several pressure and temperature profiles, as I am not sure of all the profiles, I will be glad to have the possibility to not re-launch all my simulation each time.
I am available for any more further informations.
thanks in advance
I am starting on abaqus and this question can seem obvious but I was wondering if It's possible to start a calculation from previous results on ABAQUS. By the way, I am trying to simulate the deformation of a pipe under several pressure and temperature profiles, as I am not sure of all the profiles, I will be glad to have the possibility to not re-launch all my simulation each time.
I am available for any more further informations.
thanks in advance





RE: codes to restart a simulation from previous results
“Restarting an analysis,” Section 9.1.1 of the Abaqus Analysis User's Manual
RE: codes to restart a simulation from previous results