how to apply load to line in ANSYS
how to apply load to line in ANSYS
(OP)
thread727-105128: Abaqus, ANSYS, Algor, Mechanica which is the best?
how can apply load to line of edge of Aera in ANSYS in different direction?
how can apply load to line of edge of Aera in ANSYS in different direction?





RE: how to apply load to line in ANSYS
RE: how to apply load to line in ANSYS
it just applied on X direction
RE: how to apply load to line in ANSYS
------------
See FAQ569-1083: Asking questions the smart way on Eng-Tips fora for details on how to make best use of Eng-Tips.com
RE: how to apply load to line in ANSYS