NX8.5 Remember previous state in sketch
NX8.5 Remember previous state in sketch
(OP)
Hi all,
I am running the new NX8.5 for two weeks and I have a question if anyone can help me.
I can remember that in NX8.0 I could change the selection scope (attached picture) to "Within Work Part" and remember the selection afterwards. Now If I open a new session of NX, I must reselect it. It is not a big deal but maybe it is something that I am missing.
Thanks,
Spada
I am running the new NX8.5 for two weeks and I have a question if anyone can help me.
I can remember that in NX8.0 I could change the selection scope (attached picture) to "Within Work Part" and remember the selection afterwards. Now If I open a new session of NX, I must reselect it. It is not a big deal but maybe it is something that I am missing.
Thanks,
Spada





RE: NX8.5 Remember previous state in sketch
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX8.5 Remember previous state in sketch
Thank you for your reply. I am running the NX 8.5.023 version. The state ("Within Work Part") I want it to remember, is when I try to dimension a curve which was created within the sketch with an edge for example of a face (which was created before). If I reopen the NX the selection scope (Insert -> Dimensions -> Inferred) returns to "Within Active Sketch".
Thanks,
Spada