chip break tap
chip break tap
(OP)
Hi, guys
Is there any way that I can cnc tap with chip break? I can not find any choice of operations in UG nx8.0 but UG nx8 post builder has chip break tap.
how I can add this extra into operation list? I am talking about heidenhain control.
thank you
Is there any way that I can cnc tap with chip break? I can not find any choice of operations in UG nx8.0 but UG nx8 post builder has chip break tap.
how I can add this extra into operation list? I am talking about heidenhain control.
thank you





RE: chip break tap
When you list you will see CYCLE/TAP,...,OPTION
Mark Rief
Product Manager
Siemens PLM
RE: chip break tap
Are you talking about cycle type > edit parameters > specify number of > cycle parameters > option off => ##59 ?
thank you
Dave