Automotive
Automotive
(OP)
I would like to simulate movement of the car through the channel (as shown in attachment).
I have modeled a simple version of a vehicle, and i´ve imported the channel from catia. The channel is full of water.
I´ve set that the channel is ground, i´ve added the revolute joints over the wheels, i added also the x and y velocity in wheel parts and my question is now how to make this vehicle drive through the channel.
I would appriciate if someone could explain just in steps, what should i do.
Many thanks
I have modeled a simple version of a vehicle, and i´ve imported the channel from catia. The channel is full of water.
I´ve set that the channel is ground, i´ve added the revolute joints over the wheels, i added also the x and y velocity in wheel parts and my question is now how to make this vehicle drive through the channel.
I would appriciate if someone could explain just in steps, what should i do.
Many thanks





RE: Automotive
RE: Automotive
RE: Automotive
Cheers
Greg Locock
New here? Try reading these, they might help FAQ731-376: Eng-Tips.com Forum Policies http://eng-tips.com/market.cfm?