How to give dimensions in assembly
How to give dimensions in assembly
(OP)
Hi All,
Do we have an option in NX apart from PMI dimension through which we can give dimesions such as overall height,length and width. Plz have a look at the below attached image to have a better understanding about the requirement.
Do we have an option in NX apart from PMI dimension through which we can give dimesions such as overall height,length and width. Plz have a look at the below attached image to have a better understanding about the requirement.





RE: How to give dimensions in assembly
Might be a good place to start.
www.nxjournaling.com