iProperties - Inventor Pro 2011
iProperties - Inventor Pro 2011
(OP)
Hi All,
I'm not sure whether this is a Windows problem or an Inventor one. I have well over a five hundred parts now created for our products with many more to follow.
In the iProperties box under Summary I fill in Title, Author etc and under Project I fill in various other boxes.
When I go to open a file I cannot see any of this information showing up in the Open File box. Yes I have the Title and Description headings switched on but nothing is displayed under them. It would make life a lot easier when searching for a part, to see either of these and quickly run through the list.
Rgds
Dave R
I'm not sure whether this is a Windows problem or an Inventor one. I have well over a five hundred parts now created for our products with many more to follow.
In the iProperties box under Summary I fill in Title, Author etc and under Project I fill in various other boxes.
When I go to open a file I cannot see any of this information showing up in the Open File box. Yes I have the Title and Description headings switched on but nothing is displayed under them. It would make life a lot easier when searching for a part, to see either of these and quickly run through the list.
Rgds
Dave R





RE: iProperties - Inventor Pro 2011
I don't use Vault but would expect this issue is handled much better in there. Do you use Vault?
RE: iProperties - Inventor Pro 2011
Yes, Windows is like this. They hate to think that if they are not incontrol of things then they won't allow it.
No I don't use vault, but if there's a chance that it would operate better this way I'm prepared to look at it.
Rgds,
Dave R