Helical Flange?
Helical Flange?
(OP)
I'm trying to recreate a helical lockwasher that was built from a couple of flanges. I can't figure out how these features were applied; I can't generate anything like the menu that I get when I edit the existing features (jpg attached). They started with an .001mm thick extrusion setting up the x-sec. Any help is greatly appreciated.





RE: Helical Flange?
www.nxjournaling.com
RE: Helical Flange?
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.