Bolts in NX
Bolts in NX
(OP)
Hi, can anyone help me with a simulation in Siemens NX 8. I have a 3 mm thick abs solid with three holes for the axle and two bolts. I want to bolt this http://arduino-direct.com/sunshop/index.php?l=product_detail&p=120 motor to the solid and see how the plastic behaves.
I have made a placeholder for the motor, and an OK with assuming that the motor and bolts will be a lot stronger than the plastic.
How do I define a connection between the motor and the abs-plate?
TL:DR How to simulate bolts in Simens NX?
-Arnty
I have made a placeholder for the motor, and an OK with assuming that the motor and bolts will be a lot stronger than the plastic.
How do I define a connection between the motor and the abs-plate?
TL:DR How to simulate bolts in Simens NX?
-Arnty




