Damage Modeling of a beam
Damage Modeling of a beam
(OP)
Hi All,
I am running a simulation of ductile damage of a beam under flexure.
I see that the damage criterion is achieved however, the Job fails after/around the damage initiation! It gives convergence error!
How can I resolve that! Any suggestion is highly appreciated!!!
Regards,
I am running a simulation of ductile damage of a beam under flexure.
I see that the damage criterion is achieved however, the Job fails after/around the damage initiation! It gives convergence error!
How can I resolve that! Any suggestion is highly appreciated!!!
Regards,





RE: Damage Modeling of a beam
http://www.eng-tips.com/faqs.cfm?fid=376
http://www.eng-tips.com/faqs.cfm?fid=1083