OMES OMATIC 130DTR NEED HELP!!!
OMES OMATIC 130DTR NEED HELP!!!
(OP)
Hi guys, i am an engineering apprentice within fabrication engineering. 4 months after i started at my placement the autoCAD designer up and left and i was dragged into the office ever since then i have been out with the machines trying to get them up and running full time and the 130DTR punch machine is the only one that i cannot seem to get working. would appreciate any help!





RE: OMES OMATIC 130DTR NEED HELP!!!
call the sales engineer of who sold the equipment. that is your best bet.
have them go to your facility , then have them instruct you in the programing & the operating procedures.
it will cost $$, but it will be well worth it.
HTH
Mfgenggear
RE: OMES OMATIC 130DTR NEED HELP!!!
Then when the factory rep gets there you will have a fair idea of what he is talking about.
B.E.
The good engineer does not need to memorize every formula; he just needs to know where he can find them when he needs them. Old professor