NX7.5 Assembly Navigator fades when mouse is not close by when unpinned/floating
NX7.5 Assembly Navigator fades when mouse is not close by when unpinned/floating
(OP)
I was wondering if anyone knows how to stop the assembly navigator window, when unpinned, to stop the fading/invisibility of this window
i prefer to have it located on a monitor all by itself and when the mouse moves away back on to the drawing it fades to an unreadable gray invisible window...it is annoying that when the mouse get close it brightens back up again...as i have large assembles i like to review where i am time to time and i have to move the mouse over to that monitor instead on just a quick view with my eyes...
Thoughts, ideas
i prefer to have it located on a monitor all by itself and when the mouse moves away back on to the drawing it fades to an unreadable gray invisible window...it is annoying that when the mouse get close it brightens back up again...as i have large assembles i like to review where i am time to time and i have to move the mouse over to that monitor instead on just a quick view with my eyes...
Thoughts, ideas





RE: NX7.5 Assembly Navigator fades when mouse is not close by when unpinned/floating
thread561-296937: NX6 Assembly Nav undocking fade out
www.nxjournaling.com
RE: NX7.5 Assembly Navigator fades when mouse is not close by when unpinned/floating
:)http://www.eng-tips.com/viewthread.cfm?qid=331852