crop view
crop view
(OP)
Hi,
I am trying to crop a view.
the screen message says to sketch a closed profile in the view, i have tried this & it dose not crop the view.
What am I missing in the steps
Thank You
I am trying to crop a view.
the screen message says to sketch a closed profile in the view, i have tried this & it dose not crop the view.
What am I missing in the steps
Thank You
NX 3.0 NX 5.0 NX 7.5 NX 8.0
Solidworks 11, 12
HP Mobile Workstation 8730W
XP Pro






RE: crop view
Double-click the view you want to crop, go to the sketch tab, draw an enclosed shape (I usually use some sort of rectangle and occasionally a circle) around the area you want to crop, then with the sketch still highlighted, go to the view layout tab and click Crop View. That should be it done.
RE: crop view
RE: crop view
-handleman, CSWP (The new, easy test)
RE: crop view
RE: crop view
I found crop view quite frustrating until I realised you can apply a crop to the sheet, which in some cases can be an empty space! Same goes for notes - add them to the view and if you move the view the note travels with it: otherwise it'll stay wherever you placed it on the sheet.